Differences

This shows you the differences between two versions of the page.

--- testplaninv:30:use:editmark [2026/03/02 10:31]
admin [Characteristic Type: Hole/Thread]
+++ testplaninv:30:use:editmark [2026/03/02 15:15] (current)
admin [Characteristic Type: Simple Value]
@@ Line 60: / Line 60: @@
 |Angle  |Displays the angle determined from the Inventor feature. Detailed information on target value and tolerance: Can be entered in the subdialogue (button with arrow symbol). |
-<note>Two methods are available for reading out the Inventor characteristic data: Automatic mode and the pattern-based expert mode. Both procedures are described in the chapter [[testplaninv:30:administration|Administration]].</note>
+<note>Two methods are available for reading out the Inventor characteristic data: Automatic mode and the pattern-based expert mode. Both procedures are described in the chapter [[testplaninv:38:administration|Administration]].</note>
 \\
@@ Line 100: / Line 100: @@
 The characteristic type “Hole/Thread” has the following specific properties:
-{{:testplaninv:30:use:use_012_en.png?400|}}
+{{:testplaninv:38:usage:screenshots:use_012_en.png?400|}}
 ^ Name ^ Description ^
@@ Line 117: / Line 117: @@
 The characteristic type "Simple value" is a free inspection characteristic that is independent of Inventor and has the following specific properties:
-{{:testplaninv:30:use:use_014_en.png?400|}}
+{{:testplaninv:38:usage:screenshots:use_014_en.png?401|}}
 ^ Name ^ Description ^

REITEC Help