Differences

This shows you the differences between two versions of the page.

--- testplaninv:30:use:automark [2018/05/25 14:03]
admin [Command: Generate Stamp Icons]
+++ testplaninv:30:use:automark [2026/03/02 10:41] (current)
admin [Command: Generate Stamp Icons]
@@ Line 1: / Line 1: @@
 ====== Command: Generate Stamp Icons ======
-{{:de:testplaninv:use:createauto_32.png?nolink&32 |}}
+{{:testplaninv:38:usage:createauto_32.png?nolink&32 |}}
 This command automatically marks all inspection characteristics of a drawing. Depending on the setting, the function is only applied to the current sheet or to all sheets.The marking is done clockwise view by view. The numbering is in ascending order.
@@ Line 13: / Line 13: @@
 During the generation process, all required values are read from the Inventor characteristic, stored in a test plan characteristic and supplemented by further data such as the characteristic number. The different types of characteristics are explained in chapter [[testplaninv:30:use:editmark|Edit mark]].
-====== Activate filter ======
+===== Activate filter =====
 Basically, all supported Inventor characteristics are always marked. The filter dialog upstream of the labeling process can be used to restrict the labeling to certain types of characteristics.
-{{:testplaninv:30:use:use_022_en.png?400|}}
+{{:testplaninv:38:usage:screenshots:use_022_en.png?280|}}
 The filter settings can also be adjusted in the options.
+----
+The content refers to version 3.8

REITEC Help