Differences

This shows you the differences between two versions of the page.

--- testplaninv:30:use:automark [2018/05/25 13:55]
admin created
+++ testplaninv:30:use:automark [2019/05/20 13:02] (current)
@@ Line 11: / Line 11: @@
   * Geometric tolerances
-During the generation process, all required values are read from the Inventor characteristic, stored in a test plan characteristic and supplemented by further data such as the characteristic number. The different types of characteristics are explained in chapter [[en:testplaninv:30:use:editmark|Edit inspection characteristic]].
+During the generation process, all required values are read from the Inventor characteristic, stored in a test plan characteristic and supplemented by further data such as the characteristic number. The different types of characteristics are explained in chapter [[testplaninv:30:use:editmark|Edit mark]].
-====== Activate filter ======
+===== Activate filter =====
 Basically, all supported Inventor characteristics are always marked. The filter dialog upstream of the labeling process can be used to restrict the labeling to certain types of characteristics.
-{{:testplaninv:30:use:use_022_en.png?400|}}
+{{:testplaninv:30:use:use_022_en.png?300|}}
 The filter settings can also be adjusted in the options.
+----
+The content refers to version 3.0

REITEC Help