This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
testplaninv:changelog [2019/10/15 10:20] admin [Version 3.2.3.0] |
testplaninv:changelog [2020/04/08 13:18] admin [Version 3.2.3.0] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Change Log ====== | ====== Change Log ====== | ||
+ | ====== Version 3.3.1.0 ====== | ||
+ | * Rounding problem with minor deviations at 10th decimal place e.g. 91.499999999999 | ||
+ | * Updating the characteristic data when updating (& re-number) the stamps | ||
+ | * Improvement when processing overwritten chamfer designations | ||
+ | * Support of Inventor 2021 | ||
+ | |||
+ | ====== Version 3.3.0.0 ====== | ||
+ | * Export DFD file format | ||
+ | * Calculation of general tolerances for holevalues | ||
+ | * A file property can now be used to specify that numbering can no longer be changed | ||
+ | * Error: If no thread data is available (e.g. for a hole) no empty row is exported anymore | ||
+ | * Individual marking of dimension groups e.g. chain dimensions, coordinate dimensions | ||
+ | * Exclusion/ | ||
+ | * Acquisition of additional characteristic data in user-defined properties | ||
+ | * Export of calculated values | ||
+ | * Indication " | ||
+ | |||
+ | |||
===== Version 3.2.3.0 ===== | ===== Version 3.2.3.0 ===== | ||
* Drawing is marked as edited even if no change was necessary | * Drawing is marked as edited even if no change was necessary |